Wholesale LED Wall Rental Cost Factory – Indoor P3.0 High Refresh Rate LED Display Module – Jucai

Remarks & Key Precautions

1.Indoor Q3.0 Pro can go with 640*480mm MG cabinet, suggestion cabinet model is QM-Pro-2.
2.Indoor Q3.0 Pro uses HUB75E.
3.Temperature requirement:

• 1) Storage temperature range: -10℃-30℃, over 30℃ needs to do cooling treatment. Lamp surface temperature(working period): ≤60℃, temperature control equipment is required to be installed when temperature exceeding the standard.

4.Humidity requirement:

• Storage humidity range: 10% RH-60% RH, humidity over 60% RH requires dehumidification treatment.

5.Keep away from water: Indoor products have low level of protection, water can make the module short circuit, and leads to circuit device damage, so it is necessary to keep away from the water source.
6.Corrosive gas contains salt or acid gas in the environment, may cause corrosion of electronic components, crystallization, leakage and so on.
7.when hoisting and installing the box, the height of the box shall be ≤15 to ensure the safety of load-bearing structural parts
8.Each group of 220V power cord (2.5mm2 copper wire) is allowed to load up to 9 cabinets,the incoming load of each group of network cables should be determined according to the system card parameters actually configured on the screen.

Application

Q3.0 Pro, Hospital, 44sqm